Avaya Communication Manager Administrator's Manual page 837

Note:
You can enter x in the Port field to indicate that there is no hardware associated
Note:
with the port assignment (also known as Administration Without Hardware
(AWOH). These stations are referred to as "phantom stations." If this data
module is designated as a secondary data module (Secondary data module set
to y) An x cannot be entered into this field. The port of a primary data module
cannot be changed to x if a secondary data module is administered.
Remote Loop-Around Test
Used with Processor/Trunk and X.25 Data Modules. Appears when the Type field is pdm, tdm,
or x.25.
Valid entries
y/n
y/n
Secondary data module
Used with Processor/Trunk Data Modules. Appears only when the Type field is pdm. The
primary data module must be administered before the secondary data module may be added. If
the Port field is x, the Secondary Data Module field cannot be y.
Valid entries
y
n
Subnet Mask
Used with Point-to-Point data modules (for S8700 Series IP-Connect). See Administration for
Network Connectivity for Avaya Communication Manager, 555-233-504, for more information.
Usage
For Processor/Trunk Data Modules, enter y if the data
module supports a loop-back test at the EIA interface.
In general, Avaya equipment supports this test but it is
not required by Level 2 Digital Communications
Protocol. Enter n to abort a request for this test.
For X.25 Data Modules, enter y to allow remote
loop-around tests on this port. See the maintenance
manual for your model for more information about
remote loop-around tests. Enter n to abort a request for
this test.
Usage
This PDM is the secondary data module used for Dual
I-channel AUDIX networking.
This is the primary PDM, or if this data module is not
used for AUDIX networking.
Data Module
Issue 1 June 2005 837