Error Logging - Avaya Communication Manager Administrator's Manual

Screen Reference
Endpoint Type
Used with X.25 Data Modules. An endpoint type is a type of packet switched data endpoint that
uses X.25 call control procedures. The X.25 Endpoint connects to external ports on the PGATE
board and to the TDM bus via a DS1 trunk. Ports connected to the adjunct endpoint can be
either DTEs or DCEs. The type of endpoint (DTE or DCE) is administrable on the "data-mod"
screen.
Valid entries
adjunct

Error Logging

Used with X.25 Data Modules.
Valid entries
y/n
Establish Connection
Used with X.25, Point-to-Point, and Processor Interface (used with DEFINITY CSI only) data
modules. See Administration for Network Connectivity for Avaya Communication Manager,
555-233-504 for more information.
Highest PVC Logical Channel
A display-only field used with X.25 Data Modules. Appears when the Permanent Virtual
Circuit field is y. Specifies how the above endpoint type acts.
Valid entries
1 to 64
IP Address Negotiation
Used with Point-to-Point data modules. Does not appear for S8700 Series IP-Connect. See
Administration for Network Connectivity for Avaya Communication Manager, 555-233-504, for
more information.
832 Administrator Guide for Avaya Communication Manager
Usage
Mandatory entry.
Usage
Enter y to record X.25 protocol errors in the hardware
error log. See the maintenance manual for your model
for more information about error logs.
Usage
Indicates that 1 to 64 Logical Channels are allowed on
this port.