Avaya Communication Manager Administrator's Manual page 274

Routing Outgoing Calls
2. Record the route pattern for the selected dialed string.
In our example, the route pattern for 1800 is p1. This indicates that the system uses the
Partition Routing Table to determine which route pattern to use for each partition.
Note:
If there was a number (with no p) under Route Pattern on the Route Chosen
Note:
Report, then all partitions use the same route pattern. You need to use the
Partition Routing Table only if you want to use different route patterns for different
partition groups.
3. Press Cancel to return to the command prompt.
4. Type change partition-route-table index 1 and press Enter.
The Partition Routing Table
1800 calls and these calls use route pattern 30.
Figure 118: Partition Routing Table screen
Route
Index
-----
1
2
3
4
5
6
7
5. In the PGN2 column that corresponds to Route Index 1, type 30 and press Enter.
This tells the system to use route pattern 30 for partition group 2 and allow partition group 2
members to make calls to 1800 numbers.
Assigning a telephone to a partition group
To assign an extension to a partition group, first assign the partition group to a COR, and then
assign that COR to the extension.
274 Administrator Guide for Avaya Communication Manager
screen appears. In our example, partition group 1 can make
Partition Routing Table
Routing Patterns
PGN 1 PGN 2 PGN 3
----- ----- -----
__30 ____ ____
____ ____ ____
____ ____ ____
____ ____ ____
____ ____ ____
____ ____ ____
____ ____ ____
PGN 4 PGN 5 PGN 6
----- ----- -----
____ ____ ____
____ ____ ____
____ ____ ____
____ ____ ____
____ ____ ____
____ ____ ____
____ ____ ____
PGN 7 PGN 8
----- -----
____ ____
____ ____
____ ____
____ ____
____ ____
____ ____
____ ____