Avaya Communication Manager Administrator's Manual page 111

Figure 34: Trunk Group screen
add trunk-group next
Group Number: 6___
Group Name: ___________________________ COR: __
Direction: ________
Dial Access? _
Queue Length: ___
Service Type: _____
TRUNK PARAMETERS
Trunk Type (in/out): ____________
Outgoing Dial Type: _________
Digit Treatment: __________
Analog Loss Group: ___
Incoming Dial Tone? _
Incoming Calling Number - Delete: ___ Insert: _______ Format: _______
Disconnect Supervision - In? _
Answer Supervision Timeout: ___
2. In the Group Type field, type ISDN.
ISDN-PRI or ISDN-BRI must be y on the System Parameters Customer Options screen.
3. In the TAC field, type in the trunk access code that conforms to your dial plan.
4. In the Carrier Medium field, type IP (Medpro).
5. In the Dial Access field, type y.
6. In the Service Type field, type tie.
7. In the Signaling Group field, type in the signaling group you created.
8. Press Enter to save your changes.
Setting up a signaling group
Each Remote Office has own listen port and signaling group. Set up a new trunk group, or use
an existing trunk group administered for H.323 signaling.
Outgoing Display? _
BCC: _
Bit Rate: _____
TRUNK GROUP
Group Type: ________
Trunk Signaling Type: ____
Busy Threshold: ___
Incoming Destination: ________
Auth Code? _
Trunk Flash? _
ITC? ____
Incoming Rotary Timeout(sec): __
Incoming Dial Type: ________
Disconnect Timing(msec): ____
Sig Bit Inversion: none
Digital Loss Group: ___
Synchronization: _____
Out? _
Receive Answer Supervision? _
Setting up Remote Office
Page 1 of x
CDR Reports: _
TN: ___ TAC: __6__
Night Service: ________
Digits: ____
Duplex: ____
Issue 1 June 2005 111