Avaya Communication Manager Administrator's Manual page 330

Managing MultiMedia Calling
12. The Idle Code default is 11111111.
13. The DCP/Analog Bearer Capability default is 3.1 kHz.
14. Set the MMI Cabling Board field to xxxxx (where xxxxx is the location of the TN787 MMI
circuit pack recorded in step 2). This must be the slot for port B of the Y-cable.
15. The MMI Interface field ESM appears.
16. Enter add signaling-group next. The Signaling Group screen appears.
Figure 150: Signaling Group screen
change signaling-group 6
Group Number: 6
17. Set the Associated Signaling field to y.
18. Set the Primary D-Channel Port field to xxxx16 (where xxxx is the address of the
TN2207 PRI circuit pack, for example: 1B0516).
19. The Max Number of NCA TSC default is 0.
20. The Max Number of GA TSC default is 0.
21. Trunk Group for NCA TSC ____ (leave blank).
22. Trunk Group for Channel Selection____ (leave blank).
23. Logoff the terminal and then log back on the terminal to view your changes.
Troubleshooting
To determine ESM link status, enter the following commands from the system administration
terminal:
1.Status esm
2.Status signaling-group
3.List MMI
Note:
When you move ESM circuit packs, you MUST remove the DS1 and signaling
Note:
group translations. You cannot use the change circuit pack command.
330 Administrator Guide for Avaya Communication Manager
Associated Signaling? y
Primary D-Channel: 01C0916
Trunk Group for Channel Selection:
Supplementary Service Protocol: a
SIGNALING GROUP
Trunk Group for NCA TSC:
Page 1 of
Max number of NCA TSC: 0
Max number of CA TSC: 0
5