Avaya Communication Manager Administrator's Manual page 218

Handling Incoming Calls
Setting up trunk group night service
You can use trunk group night service if you want to direct individual trunk groups to night
service. The system redirects calls from the trunk group to the group's night service destination.
Trunk group night service overrides night station service. For example, we will say you activate
trunk group night service, and then your attendant activates night station service. In this case,
calls to the trunk group use the trunk night service destination, rather than the station night
service destination.
Instructions
We will direct night calls for trunk group 2 to extension 1245.
To set up trunk group night service:
1. Type change trunk-group 2 and press Enter.
The Trunk Group
Figure 84: Trunk Group screen
Group Number: 2
Group Name: outside calls
Direction: two-way_
Dial Access? n
Queue Length: 0
Comm Type: voice
Prefix-1? y
TRUNK PARAMETERS
Outgoing Dial Type: tone
Trunk Termination: rc
Analog Loss Group: ___
Disconnect Supervision - In? y
Answer Supervision Timeout: 10
2. Type 1245 in the Night Service field.
The destination can be a station extension, a recorded announcement extension, a vector
directory number, a hunt group extension, a terminating extension group, or attd if you want
to direct the call to the attendant.
3. Press Enter to save your changes.
218 Administrator Guide for Avaya Communication Manager
screen appears.
COR: 1_
Outgoing Display? n
BCC: _
Trunk Type: loop-start
Auto Guard? n Call Still Held? n
Bit Rate: 1200
TRUNK GROUP
Group Type: co
TN: 1__
Busy Threshold: 99
Country: 1_ Incoming Destination: ________
Auth Code? n Digit Absorption List: _
Trunk Flash? n
Disconnect Timing(msec): 500_
Sig Bit Inversion: none
Digital Loss Group: ___
Trunk Gain: high
Synchronization: _____
Out? n
Receive Answer Supervision? n
CDR Reports: y
TAC: ____
Night Service: 1245
Toll Restricted? y
Cut-Through? n
Duplex: ____