Show Multicast Usage - Juniper JUNOS OS 10.4 - FOR EX REV 1 Manual

show multicast usage

Syntax
Syntax (EX Series
Switch)
Release Information
Description
Options
Required Privilege
Level
List of Sample Output
Output Fields
Copyright © 2010, Juniper Networks, Inc.
show multicast usage
<brief | detail>
<inet | inet6>
<instance instance-name>
<logical-system (all | logical-system-name)>
show multicast usage
<brief | detail>
<inet | inet6>
<instance instance-name>
Command introduced before Junos OS Release 7.4.
Command introduced in Junos OS Release 9.0 for EX Series switches.
and options introduced in Junos OS Release 10.0 for EX Series switches.
inet6 instance
Display usage information about the 10 most active Distance Vector Multicast Routing
Protocol (DVMRP) or Protocol Independent Multicast (PIM) groups.
—Display multicast usage information for all supported address families for all
none
routing instances.
brief | detail —(Optional) Display the specified level of output.
—(Optional) Display usage information for IPv4 or IPv6 family addresses,
inet | inet6
respectively.
instance instance-name —(Optional) Display information about the most active DVMRP
or PIM groups for a specific multicast instance.
logical-system (all | logical-system-name)
systems or on a particular logical system.
view
show multicast usage on page 2710
show multicast usage brief on page 2710
show multicast usage instance on page 2710
show multicast usage detail on page 2710
Table 361 on page 2709 describes the output fields for the
Output fields are listed in the approximate order in which they appear.
Table 361: show multicast usage Output Fields
Field Name Field Description
Name of the routing instance. (Displayed when multicast is configured within
Instance
a routing instance.)
Chapter 86: Operational Commands for IGMP Snooping and Multicast
—(Optional) Perform this operation on all logical
show multicast usage command.
2709