Table 17: Show Ppp Interface Mlppp Output Fields - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual

Meaning
Copyright © 2010, Juniper Networks, Inc.
multiclass-classes
multiclass-sequence-format
...
1 mlppp interfaces found
Table 17 on page 355 lists the show ppp interface mlppp command output fields.

Table 17: show ppp interface mlppp Output Fields

Field Name
PPP interface mlppp bundleName
PPP multilink member-interface
interfaceName
Link interface administrative
status
PPP multilink multiclass
PPP multilink multiclass classes
PPP multilink multiclass
fragmentation
PPP multilink multiclass
reassembly
mlppp interfaces found
Time since last baseline
receive class, transmit class
Chapter 10: Configuring Multiclass Multilink PPP
4
long
Field Description
Name and state (up or down) of the MLPPP interface
Name and state (up or down) of the MLPPP member
link interface
Administrative state of the member link interface:
open (enabled) or closed (disabled)
Configuration of multiclass MLPPP on the MLPPP
interface: enabled or disabled
Number of multilink classes created on the MLPPP
interface: 1 through 8
Configuration of fragmentation of the multiclass
MLPPP interface: enabled or disabled. If
fragmentation is enabled then the command also
lists the QoS traffic classes on which fragmentation
is enabled.
Configuration of reassembly of the multiclass MLPPP
interface: enabled or disabled. If reassembly is
enabled then it also lists the QoS traffic classes on
which reassembly is enabled.
Number of MLPPP interfaces configured
When baselining is configured, the time since the last
baseline was set is displayed in hours:minutes:seconds
or days/hours format
Number of multilink classes configured on the MLPPP
bundle
4
long
355