Juniper JUNOS OS 10.4 - FOR EX REV 1 Manual page 2776

Complete Software Guide for Junos
Table 345: show igmp interface Output Fields (continued)
Field Name Field Description
IGMP version being used on the interface:
Version
Number of groups on the interface.
Groups
State of the immediate leave option:
Immediate Leave
—Indicates that the router removes a host from the multicast group as soon as the
On
router receives a leave group message from a host associated with the interface.
—Indicates that after receiving a leave group message, instead of removing a host
Off
from the multicast group immediately, the router sends a group query to determine if
another receiver responds.
State of the promiscuous mode option:
Promiscuous Mode
On —Indicates that the router can accept IGMP reports from subnetworks that are not
associated with its interfaces.
Off —Indicates that the router can accept IGMP reports only from subnetworks that
are associated with its interfaces.
State of the passive mode option:
Passive
—Indicates that the router can run IGMP on the interface but not send or receive
On
control traffic such as IGMP reports, queries, and leaves.
—Indicates that the router can run IGMP on the interface and send or receive control
Off
traffic such as IGMP reports, queries, and leaves.
The
passive
three available query or control traffic options. When enabled, the following options
appear after the
send-general-query
send-group-query
queries.
allow-receive
Name of the OIF map associated to the interface.
OIF map
Name of the source-specific multicast (SSM) map (if configured) used on the interface.
SSM map
Information configured by the user:
Configured
Parameters
IGMP Query Interval
queries when it is the querier.
IGMP Query Response Interval
response to a general query.
IGMP Last Member Query Interval
in response to a group-specific query.
IGMP Robustness Count
2672
®
OS for EX Series Ethernet Switches, Release 10.4
statement enables you to selectively activate up to two out of a possible
state declaration:
on
—The interface sends general queries.
—The interface sends group-specific and group-source-specific
—The interface receives control traffic
—Interval (in seconds) at which this router sends membership
—Time (in seconds) that the router waits for a report in
—Time (in seconds) that the router waits for a report
—Number of times the router retries a query.
, , or .
1 2 3
Copyright © 2010, Juniper Networks, Inc.
Level of Output
All levels
All levels
All levels
All levels
All levels
All levels
All levels
All levels