Juniper JUNOS OS 10.4 - FOR EX REV 1 Manual page 1390

Complete Software Guide for Junos
1286
®
OS for EX Series Ethernet Switches, Release 10.4
To configure the link settings:
Set link settings for a Gigabit Ethernet interface:
[edit]
user@switch# set interfaces ge-fpc/pic/port ether-options
Set link settings for a 10-Gigabit Ethernet interface:
[edit]
user@switch# set interfaces xe-fpc/pic/port ether-options
NOTE: On EX Series switches,
On EX2200 switches, EX3200 switches, EX4200 standalone switches,
and EX4500 switches, FPC refers to the switch itself. The FPC number is
always 0 on these switches.
On EX4200 switches configured in a Virtual Chassis, the FPC number
indicates the member ID of the switch within the Virtual Chassis, from
through 9 .
On EX8200 standalone switches, the FPC number indicates the slot number
of the line card that contains the physical interface.
On an EX8200 Virtual Chassis, the FPC number indicates the slot number
of the line card on the Virtual Chassis. The line card slots on Virtual Chassis
member 0 are numbered 0 through 15; on member 1, they are numbered
16 through 31, and so on.
pic can have the following values:
On EX2200, EX3200, EX4200, and EX4500 switches, the PIC number is
for all built-in interfaces (interfaces that are not an uplink port).
0
On EX2200, EX3200, and EX4200 switches, the PIC number is
ports.
On EX4500 switches, the PIC number is
uplink module and
On EX8200 switches, the PIC number is always
The ether-options statement allows you to modify the configuration:
—Specify an aggregated Ethernet bundle. See "Configuring Aggregated Ethernet
802.3ad
Interfaces (CLI Procedure)" on page 1330.
auto-negotiation —Enable or disable autonegotation of flow control, link mode, and
speed.
—Enable or disable flow control.
flow-control
link-mode —Specify full-duplex
can have the following values:
fpc
for uplink ports on the left-hand
1
2 for uplink ports on the right-hand uplink module.
, half-duplex , or automatic
Copyright © 2010, Juniper Networks, Inc.
0
1 for uplink
.
0
.