Juniper JUNOS OS 10.4 - FOR EX REV 1 Manual page 1420

Complete Software Guide for Junos
Example: Specifying an
Interface Range
Member Range
Example: Specifying an
Interface Range
Member
Example: Interface
Range Common
Configuration
1316
®
OS for EX Series Ethernet Switches, Release 10.4
A range for a member statement should contain the following:
—All, specifies all available interfaces.
*
num —Number, specifies one specific interface by its number.
—Numbers between low to high, specifies a range of sequential interfaces.
[low-high]
[num1, num2, num3] —Numbers
interfaces.
member-range ge-0/0/0 to ge-4/0/40;
To specify one or multiple members, use the
hierarchy level.
interface-range name]
To specify the list of interface range members individually or for multiple interfaces using
regex, use the
member list of interface names
member ge-0/0/0;
member ge-0/*/*
member ge-0/[1-10]/0;
member ge-0/[1,2,3]/3;
Regex or wildcards are not supported for interface-type prefixes. For example, prefixes
ge , fe , and xe must be mentioned explicitly.
An definition can contain both
interface-range
within it. There is no maximum limit on the number of
statements within an interface-range. However, at least one
statement must exist within an
Configuration common to an interface range can be added as a part of the
definition, as follows:
[edit]
interfaces {
+ interface-range foo {
+ member-range ge-1/0/0 to ge-4/0/40;
+ member ge-0/1/1;
+ member ge-5/[1-10]/*;
/*Common configuration is added as part of interface-range definition*/
mtu 256;
hold-time up 10;
ether-options {
flow-control;
speed {
100m;
}
802.3ad primary;
}
}
}
num1 , num2 , and num3
statement at the
member
statement.
and
member
member
definition.
interface-range
Copyright © 2010, Juniper Networks, Inc.
specify multiple specific
[edit interfaces
statements
member-range
or member-range
or
member member-range
interface-range