Table 188: Port Edit Options - Juniper JUNOS OS 10.4 - FOR EX REV 1 Manual

Table 188: Port Edit Options

Field Function
Port Role Specifies a profile (role) to assign to the interface.
NOTE: Once a port role is configured on the
interface, you cannot specify VLAN options or IP
options.
NOTE: Only the following port roles can be
applied on EX8200 switch interfaces:
Default
Layer 2 uplink
Routed uplink
Default Applies the default role.
The interface family is set to
port mode is set to
Desktop Applies the desktop role.
The interface family is set to
port mode is set to
the
edge
security parameters (MAC limit =1; dynamic ARP
inspection and DHCP snooping enabled) are set.
Desktop and Applies the desktop and phone role.
Phone
The interface family is set to
port mode is set to
parameters (MAC limit =1; dynamic ARP
Inspection and DHCP snooping enabled) are set,
and recommended CoS parameters are specified
for forwarding classes, schedulers, and classifiers.
See Table 189 on page 1292 for more CoS
information.
Copyright © 2010, Juniper Networks, Inc.
Configure the interface by configuring options in the selected option set. See Table
4.
188 on page 1289 for details on options.
Repeat steps 3 and 4 for the remaining option sets that you want to configure for the
5.
interface.
NOTE: To enable or disable the administrative status for a selected
interface, click
ethernet-switching
, and RSTP is enabled.
access
ethernet-switching
, RSTP is enabled with
access
and options, and port
point-to-point
ethernet-switching
, port security
access
or
Enable Port Disable Port
Your Action
1. Click Details to view CLI commands for this role.
2. Click .
OK
,
1. Select an existing VLAN configuration or type the
name of a new VLAN configuration to be associated
,
with the interface.
2. Click Details to view CLI commands for this role.
3. Click OK .
1. Select an existing VLAN configuration or type the
name of a new VLAN configuration to be associated
,
with the interface.
You can also select an existing VoIP VLAN
configuration or a new VoIP VLAN configuration to
be associated with the interface.
NOTE: VoIP is not supported on EX8200 switches.
2. Click to view CLI commands for this role.
Details
3. Click OK .
Chapter 58: Configuring Interfaces
.
1289