Port Role Configuration With The J-Web Interface (With Cli References) - Juniper JUNOS OS 10.4 - FOR EX REV 1 Manual

Complete Software Guide for Junos
Table 188: Port Edit Options (continued)
Field Function
Wireless Access Applies the wireless access point role.
Point
The interface family is set to
port mode is set to
with the
Routed Uplink Applies the routed uplink role.
The interface family is set to
recommended CoS parameters are set for
schedulers and classifiers. See Table 189 on
page 1292 for more CoS information.
Layer 2 Uplink Applies the Layer 2 uplink role.
The interface family is set to
port mode is set to
the
point-to-point
to
dhcp-trusted
None Specifies that no port role is configured for the
selected interface.
NOTE: See "Port Role Configuration with the J-Web Interface (with CLI References)" on page 1293 for details on the CLI commands
that are associated with each port role.
NOTE: For an EX8200 switch, dynamic ARP inspection and DHCP snooping parameters are not configured.
VLAN Options
1290
®
OS for EX Series Ethernet Switches, Release 10.4
ethernet-switching
, and RSTP is enabled
access
and options.
edge point-to-point
, and
inet
ethernet-switching
, RSTP is enabled with
trunk
option, and port security is set
.
Your Action
1. Select an existing VLAN configuration or type the
name of a new VLAN configuration to be associated
,
with the interface. Type the
2. Click to view CLI commands for this role.
Details
3. Click .
OK
To specify an IPv4 address:
1. Select the check box
IPv4 address
2. Type an IP address—for example:
3. Enter the subnet mask or address prefix. For
example, 24 bits represents
4. Click OK .
To specify an IPv6 address:
1. Select the check box IPv6 address
2. Type an IP address—for example:
2001:ab8:85a3::8a2e:370:7334
3. Enter the subnet mask or address prefix.
4. Click .
OK
NOTE: Ipv6 is not supported on EX2200 and EX4500
switches.
1. For this port role you can select a VLAN member and
associate a native VLAN with the interface.
,
2. Click Details to view CLI commands for this role.
3. Click OK .
Copyright © 2010, Juniper Networks, Inc.
for a new VLAN.
VLAN ID
.
.
10.10.10.10
.
255.255.255.0
.
.