Juniper JUNOS OS 10.4 - FOR EX REV 1 Manual page 1395

Table 188: Port Edit Options (continued)
Field Function
Port Mode Specifies the mode of operation for the interface:
trunk or access.
Link Options
MTU (bytes) Specifies the maximum transmission unit size for
the interface.
Speed Specifies the speed for the mode.
Duplex Specifies the link mode.
Description Describes the link.
NOTE: If the interface is part of a link aggregation
group (LAG), only the option
enabled.
Enable Auto Enables or disables autonegotiation.
Negotiation
Enable Flow Enables or disables flow control.
Control
IP Options
Copyright © 2010, Juniper Networks, Inc.
Your Action
If you select
1. Click
2. Select the VLAN and click
3. (Optional) Associate a native VLAN with the
interface.
If you select
1. Select the VLAN member to be associated with the
interface.
2. (Optional) Associate a VoIP VLAN with the interface.
Only a VLAN with a VLAN ID can be associated as a
VoIP VLAN.
NOTE: VoIP is not supported on EX8200 switches.
Click
OK
Type a value from
for Gigabit Ethernet interfaces is
Select one of the following values: 10 Mbps, 100 Mbps,
1000 Mbps, or Auto-Negotiation.
Select one:
Enter a brief description for the link.
is
Description
Select the check box to enable autonegotiation, or clear
the check box to disable it. By default, autonegotiation
is enabled.
Select the check box to enable flow control to regulate
the amount of traffic sent out of the interface, or clear
the check box to disable flow control and permit
unrestricted traffic. Flow control is enabled by default.
Chapter 58: Configuring Interfaces
, you can:
Trunk
to add a VLAN member.
Add
OK .
Access , you can:
.
through . The default MTU
256 9216
.
1514
automatic , half , or full .
1291