Aux/Hitch/Pto Fault Code 33; Aux/Hitch/Pto Fault Code 34 - New Holland T8010 Manual

Slip Set Switch Failure
Cause:
The Data Bus signaled that the slip set switch has failed.
The AUX/Hitch/PTO controller received the signal from the armrest controller.
Possible failure modes:
1. The slip set switch failed in the armrest controller (in most cases).
2. Software execution error in the armrest controller (small chance).
Solution:
The slip set switch is hard wired to the armrest controller. If the slip set switch fails in the armrest controller, the fault
code ARM 1059 should exist.
1. Check for fault code ARM 1059 at the armrest controller. If ARM 1059 exists, follow the corresponding
corrective action.
2. Check the function the armrest controller.
NOTE: See schematic section 44 on the schematic poster.
Slip Select Switch Failure
Cause:
The Data Bus signaled that the slip select switch has failed.
The AUX/Hitch/PTO controller received the signal from the armrest controller.
Possible failure modes:
1. The slip select switch failed in the armrest controller (in most cases).
2. Software execution error in the armrest controller (small chance).
Solution:
The slip select switch is hard wired to the armrest controller. If the slip select switch fails in the armrest controller,
the fault code ARM 1059 should exist.
1. Check for fault code ARM 1059 at the armrest controller. If ARM 1059 exists, follow the corresponding
corrective action.
2. Check the function the armrest controller.
NOTE: See schematic section 44 on the schematic poster.
Section 55 - Electrical System, Controller - Chapter 3

AUX/HITCH/PTO FAULT CODE 33

AUX/HITCH/PTO FAULT CODE 34

55-3-29