New Holland T8010 Manual page 1446

Hide thumbs Also See for T8010:

Table of Contents

c) At the draft pin side, measure the continuity of the pin circuit. The resistance should be 180 kohm across A

and C and 18 kohm across B and C.

NOTE: Always inspect connector ends for damaged, bent or dislocated pins when troubleshooting.

NOTE: The resistances at the draft pin side are for reference only. Incorrect resistance means a bad pin but some

bad pins may have correct resistances.

NOTE: See schematic sections 51 and 52 on the schematic poster.

Section 55 - Electrical System, Controller - Chapter 3

Chapters

Table of Contents

T8020 T8030 T8040