Dlp-B53 Set Up A Solaris Workstation For A Craft Connection To An Ons 15327 - Cisco ONS 15327 Procedure Manual

Chapter 2 Connect the PC and Log into the GUI
If you have Windows XP installed on your PC, complete the following steps:
Step 5
a.
b.
c.
d.
e.
f.
g.
h.
i.
Return to your originating procedure (NTP).
Step 6

DLP-B53 Set Up a Solaris Workstation for a Craft Connection to an ONS 15327

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Log into the workstation as the root user.
Step 1
Check to see if the interface is plumbed by typing:
Step 2
# ifconfig device
For example:
# ifconfig hme1
If the interface is plumbed, a message similar to the following appears:
Step 3
hme1:flags=1000842<BROADCAST,RUNNING,MULTICAST,IPv4>mtu 1500 index 2 inet 0.0.0.0 netmask 0
Go to Step 6.
March 2003
From the Windows Start Menu, choose Control Panel > Network Connections.
If the Network Connections menu is not available, click Switch to Classic View.
Note
In the Network Connections dialog box, click the Local Area Connection icon.
In the Local Area Connection Properties dialog box, choose Internet Protocol (TCP/IP), then click
Properties.
In the IP Address field, enter any legitimate IP address other than the node IP address of the
ONS 15327.
In the Subnet Mask field, type the same subnet mask as the ONS 15327. The default is
255.255.255.0 (24 bit).
Type the IP address entered in Step
Click OK.
In the Local Area Connection Properties dialog box, click OK.
In the Local Area Connection Status dialog box, click Close.
This task sets up a Solaris workstation for a craft connection to the ONS
15327.
None
NTP-B21 Set Up Computer for CTC, page 2-1
As needed
Onsite
None
NTP-B22 Set Up CTC Computer to Connect to the ONS 15327
d in the Gateway Address field.
Cisco ONS 15327 Procedure Guide, R4.0
2-17