Dlp-B250 Set Up Or Change Open Shortest Path First Protocol - Cisco ONS 15327 Procedure Manual

NTP-B169 Set Up CTC Network Access
Note
Return to your originating procedure (NTP).
Step 6

DLP-B250 Set Up or Change Open Shortest Path First Protocol

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Step 1 From node view, click the Provisioning > Network > OSPF
Step 2 On the top left side of the OSPF pane, complete the following:
•
•
Under OSPF on LAN, complete the following:
Step 3
•
•
By default, OSPF is set to No Authentication. If the OSPF router requires authentication, complete the
Step 4
following steps. If not, continue with
a.
b.
Cisco ONS 15327 Procedure Guide, R4.0
3-10
Static route networking examples are provided in the IP networking section of the Cisco ONS
15327 Reference Manual.
This task enables the Open Shortest Path First (OSPF) routing protocol on
the ONS 15327. Perform this task if you want to include the ONS 15327 in
OSPF-enabled networks.
None
NTP-B24 Verify Card Installation, page 3-2
DLP-B60 Log into CTC, page 2-23
You will need the OSPF Area ID, Hello and Dead intervals, and
authentication key (if OSPF authentication is enabled) provisioned on the
router that the ONS 15327 is connected to.
As needed
Onsite or remote
Provisioning or higher
DCC/GCC OSPF Area ID Table—In dotted decimal format, enter the number that identifies the
ONS 15327s as a unique OSPF area ID. It can be any number between 000.000.000.000 and
255.255.255.255. The number must be unique to the LAN OSPF area.
DCC Metric—This value is normally unchanged. It sets a "cost" for sending packets across the
DCC, which is used by OSPF routers to calculate the shortest path. This value should always be
higher than the LAN metric. The default DCC metric is 10. The metric changes to 100 if you check
the OSPF Active on LAN check box in
OSPF active on LAN—When checked, enables the ONS 15327 OSPF topology to be advertised to
OSPF routers on the LAN. Enable this field on ONS 15327s that directly connect to OSPF routers.
LAN Port Area ID—Enter the OSPF area ID (dotted decimal format) for the router port where the
ONS 15327 is connected. (This number is different from the DCC OSPF Area ID.)
Click the No Authentication button.
On the Edit Authentication Key dialog box, complete the following:
– Type—Choose Simple Password.
Enter Authentication Key—Enter the password.
–
tabs.
Step 3.
Step 5.
Chapter 3 Turn Up Node
March 2003