Installing The Cable-Management Arm - Cisco IPS-4240-K9 - Intrusion Protection Sys 4240 Installation Manual

Chapter 4 Installing IDS-4235 and IDS-4250
Figure 4-7
Step 8 Press the slide release latch at the side of each latch to slide the appliance completely into the rack (see
Figure
Push in and turn the captive thumbscrews on each side of the front chassis panel to secure the appliance
Step 9
to the rack.

Installing the Cable-Management Arm

You can install the cable-management arm on the right or left of the rack cabinet. This procedure
describes installing the cable-management arm in the right side of the rack cabinet, as viewed from the
back.
Tip If you are installing several appliances in the rack, consider installing the cable management arms on
alternating sides of the rack for ease in cable routing.
78-16124-01
Installing the Appliance in the Rack
4-7).
Installing Cisco Intrusion Prevention System Appliances and Modules 5.0
Installing the Accessories
4-21