Installing The Cable-Management Arm - Cisco IDS-4230-FE - Intrusion Detection Sys Fast Ethernet Sensor Installation And Configuration Manual

Installing the Accessories
Step 8
Step 9

Installing the Cable-Management Arm

Tip
Step 1
Step 2
Step 3
Step 4
Cisco Intrusion Detection System Appliance and Module Installation and Configuration Guide Version 4.1
5-28
Press the slide release latch at the side of each latch to slide the appliance
completely into the rack (see
Push in and turn the captive thumbscrews on each side of the front chassis panel
to secure the appliance to the rack.
You can install the cable-management arm on the right or left of the rack cabinet.
This procedure describes installing the cable-management arm in the right side of
the rack cabinet, as viewed from the back.
If you are installing several appliances in the rack, consider installing the cable
management arms on alternating sides of the rack for ease in cable routing.
To install the cable-management arm, follow these steps:
Facing the back of the rack cabinet, locate the latch on the end of the right slide
assembly that you secured to the back vertical rail.
Push the tab on the back end of the cable-management arm into the latch on the
end of the slide assembly (see
The latch clicks when locked.
Note
Push the tab on the remaining free end (the front) into a mating latch on the inner
segment of the slide assembly (see
The latch clicks when locked.
Note
Install a stop block on the latch on the end of the opposite slide assembly (see
Figure 5-8 on page 5-29).
Chapter 5 Installing the IDS-4235 and IDS-4250
Figure 5-7 on page 5-27).
Figure 5-8 on page 5-29).
Figure 5-8 on page 5-29).
78-15597-02