Chapter 5
Connectors and Cabling
Table 5-5
Pin Number
4
5
6
7
8
Table 5-6
Table 5-6
Connector
PS-1
PS-1
PS-1
PS-1
PS-2
PS-2
PS-2
PS-2
5.2 Optical Fiber Jumper Cable Connectors
Note
Inspect and clean optical connectors prior to making optical connections. Unused optical connectors
should have plugs inserted.
5.2.1 ONS 15252 MCU Optical Connectors
Line module (LM) optical connections in the ONS 15252 MCU are listed in
optical configurations, consult with your network planner.
Table 5-7
Connector
Client IN (All CLIP modules)
Client OUT (All CLIP modules) Client output signal (from the ONS 15252 MCU)
A-side LM IN
A-side LM OUT
78-13765-01
ONS 15201 Management Access Connections (continued)
Function
Signal
CANH_RET
CAN bus return (high) from MA system
CANH
CAN bus (high) to MA system
CANL
CAN bus (low) to MA system
TERM_INSER
+4.5 VDC, 72ohms (Reserved, part of the CAN bus control)
T
NA
Not used
shows ONS 15201 SCU power supply connections.
ONS 15201 SCU Power Supply Connections
Pin Number
1
2
3
4
1
2
3
4
ONS 15252 LM Optical Connections
Connection
Client input signal (toward the ONS 15252 MCU)
A-side DWDM input signal (toward the ONS 15252 MCU)
A-side DWDM output signal (from the ONS 15252 MCU)
Voltage
–48 VDC (–)
–48 VDC (+) return
–48 VDC (–)
–48 VDC (+) return
–48 VDC (–)
–48 VDC (+) return
–48 VDC (–)
–48 VDC (+) return
Cisco ONS 15200 Installation, Setup, and Test Manual
Table
5-7. For specific
5-3