Toyota Camry Manual page 1567

DI–540
DLC1
E
1
Ts
0.13 sec.
ON
OFF
DIAGNOSTICS
BR3890
Tc
F02201
0.12 sec.
BR3904
– ANTI–LOCK BRAKE SYSTEM (BOSCH Made)
(d) Clear the DTC.
(1) Using SST, connect terminals Tc and E
DLC1.
SST 09843 – 18020
(2) Turn the ignition switch ON.
(3) Clear the DTC stored in ECU by depressing the
brake pedal 8 or more times within 3 seconds.
(4) Check that the warning light shows the normal
code.
(5) Remove the SST from the terminals of DLC2 or
DLC1.
SST 09843 – 18020
HINT:
Cancellation cannot be done by removing the battery cable or
ECU–B fuse.
2. SPEED SENSOR SIGNAL
(a) Check the speed sensor signal.
(1) When the ignition switch is turned ON, check that
the ABS warning light goes on for 2 seconds.
(2) Turn the ignition switch OFF.
(3) Using SST, connect terminals Ts and E
SST 09843 – 18020
(4) Start the engine.
(5) Check that the ABS warning light blinks.
HINT:
If the ABS warning light does not blink, inspect the ABS warning
light circuit (See page DI–565).
(6) Drive vehicle straight forward.
HINT:
Drive vehicle at 45 – 55 km/h (28 – 34 mph) for several seconds.
If the brake is applied during the check, the check routine must
be started again.
(7) Stop the vehicle.
(8) Turn the ignition switch OFF.
(9) Disconnect the SST from terminals Ts and E
connect the SST to terminals Tc and E
SST 09843 – 18020
(10) Turn the ignition switch ON.
(11) Read the number of blinks of the ABS warning light.
Author :
of DLC2 or
1
of DLC1.
1
and,
1
of DLC1.
1
Date :
775