Service-Class Bandwidth-Percentage - Dell Z9500 Reference Manual

Version
8.3.11.1
8.3.7.0
8.3.1.0
Usage By default, when rate policing and shaping, the system does not include the
Information Preamble, SFD, or the IFG fields. These fields are overhead; only the fields from
MAC destination address to the CRC are used for forwarding and are included in
these rate metering calculations.

service-class bandwidth-percentage

Specify a minimum bandwidth for queues.
Z9500
Syntax
service-class bandwidth-percentage queue0 percentage queue1
percentage queue2 percentage queue3 percentage
Parameters
percentage
Defaults none
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.1
8.2.1.0
Usage Guarantee a minimum bandwidth to different queues globally using the service-
Information
class bandwidth-percentage command from CONFIGURATION mode. The
command is applied in the same way as the bandwidth-percentage command
in an output QoS policy. The bandwidth-percentage command in QOS-
POLICY-OUT mode supersedes the service-class bandwidth-percentage
command.
1432
Description
Introduced on the Z9000.
Introduced on the S4810.
Introduced.
Enter the bandwidth-weight as a percentage. The range is
from 1 to 100.
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the C-Series and S-Series.
Quality of Service (QoS)