Ipv6 Route-Import - Dell C9000 Series Reference Manual

can configure multiple route-import targets because a VRF accepts routes from
multiple VRFs.
You can expose a unique set of routes from the source VRF for leaking to other VRFs.
When two VRFs leak or export routes, there is no option to discretely filter leaked
routes from each source VRF. You cannot import one set of routes from one VRF and
another set of routes from another VRF.
Only active routes are eligible for leaking. For example, if one VRF has two routes
corresponding to BGP and OSPF, in which the BGP route is not active, the OSPF route
takes precedence over BGP. Even though the Target VRF has specified filtering options
to match BGP, the BGP route is not leaked as that route is not active in the Source VRF.
Related

ipv6 route-import

Commands
ipv6 route-import
Import IPv6 routes leaked by another VRF using the tag specified by that VRF during export of these routes.
C9000 Series
Syntax
ipv6 route-import tag [route-map-name]
Parameters
route-import
tag
route-map-name
Command Modes
VRF MODE
CONFIGURATION
Command History
Version
9.9(0.0)
– imports IPv6 routes from another VRF.
Enter the keyword route-import to import IPv6 routes into the
VRF.
Enter a tag (ASN number) to specify an import route target for
importing routes from another VRF. To import leaked routes
from another VRF, you must use the same ASN number that is
specified as the export route target at the source VRF.
Enter the name of the route-map to filter the imported routes.
NOTE: You must use the route-map attribute while
importing routes from the global RTM. Route-maps
enable you to filter routes at the import end based on
the matching criteria that you define in the route-map.
Description
Introduced on the C9010.
Virtual Routing and Forwarding (VRF) 2270