Network structures
6.1 VLAN
6.1
VLAN
This section describes commands for configuring and managing virtual networks (VLANs).
6.1.1
The "show" commands
This section describes commands with which you display various settings.
6.1.1.1
show mac-address-table
Description
This command shows the table with the static and dynamic unicast MAC addresses and
multicast MAC addresses.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call up the command with the following parameters:
show mac-address-table [vlan<vlan-range>][address<aa:aa:aa:aa:aa:aa>]
The parameters have the following meaning:
Parameters
vlan
vlan-range
address
aa:aa:aa:aa:aa:aa
interface
interface-type
interface-id
For information on names of addresses and interfaces, refer to the section "Addresses and
interface names (Page 30)".
If you do not select any parameter from the parameter list, the entries are displayed for all
available interfaces.
138
or
cli#
[interface <interface-type><interface-id>]
Description
Keyword for a VLAN or VLAN range
Number of the addressed VLAN or VLAN
range
Keyword for a MAC address
MAC address
Keyword for a an interface description
Type or speed of the interface
Slot no. and port no. of the interface
Values
-
1 ... 4094
-
-
-
•
gigabitethernet
•
extreme-ethernet
Enter a valid interface name
SCALANCE XM-400/XR-500 Command Line Interface
Configuration Manual, 05/2014, C79000-G8976-C252-07