Table of Contents
Advertisement
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Contax
rate-limit (Ethernet)
Use the rate-limit Interface Configuration (Ethernet) mode command to
limit the incoming traffic rate on a port. Use the no form of this command to
disable the rate limit.
Syntax
committed-rate-kbps [burst committed-burst-byte]
rate-limit
no rate-limit
Parameters
•
rate—Specifies the maximum number of kilobits per second of ingress
traffic on a port. The range is 3–10000000.
•
burst bytes—The burst size in bytes (3000–19173960). If unspecified,
defaults to 128K.
Default Configuration
Rate limiting is disabled.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
Example
The following example limits the incoming traffic rate on gigabitethernet
port 1/0/5 to 150,000 kbps.
Console(config)#
Console(config-if)#
qos wrr-queue wrtd
Use the qos wrr-queue wrtd Global Configuration mode command to enable
Weighted Random Tail Drop (WRTD). Use the no form of this command to
disable WRTD.
D E L L C O N F I D E N T I A L – P R E L I M I N A R Y 5 / 1 5 / 1 2 - F O R P R O O F O N LY
744
Quality of Service (QoS) Commands
CLI\files\QoS.fm
gi1/0/
interface
rate-limit
5
150000
Advertisement
Table of Contents
