Dhcp Mode - Dell Z9500 Reference Manual

DHCP Mode

To enable and configure Dynamic Host Configuration Protocol (DHCP), use DHCP mode. For more
information, refer to Dynamic Host Configuration Protocol
To enter DHCP mode:
1. Verify that you are logged in to CONFIGURATION mode.
2. Enter the ip dhcp server command. The prompt changes to include (config-dhcp).
You can return to CONFIGURATION mode by using the exit command.
DHCP POOL Mode
To create an address pool, use DHCP POOL mode. For more information, refer to
Configuration Protocol
To enter DHCP POOL mode:
1. Verify that you are logged in to DHCP mode.
2. Enter the pool command then the pool name. The prompt changes to include (config-dhcp-pool-
name).
You can return to DHCP mode by using the exit command.
ECMP GROUP Mode
To enable or configure traffic distribution monitoring on an ECMP link bundle, use ECMP GROUP mode.
For more information, refer to ecmp_overview.
To enter ECMP GROUP mode:
1. Verify that you are logged in to CONFIGURATION mode.
2. Enter the ecmp-group command then enter the ECMP group ID. The prompt changes to include
(conf-ecmp-group-ecmp-group-id).
You can return to CONFIGURATION mode by using the exit command.
EIS Mode
To enable or configure Egress Interface Selection (EIS), use EIS mode. For more information, refer to
Commands.
To enter EIS mode:
1. Verify that you are logged in to CONFIGURATION mode.
2. Enter the management egress-interface-selection command. The prompt changes to
include (conf-mgmt-eis).
You can return to CONFIGURATION mode by using the exit command.
EXEC Mode
When you initially log in to the switch, by default, you are logged in to EXEC mode. This mode allows you
to view settings and enter EXEC Privilege mode, which is used to configure the device.
54
(DHCP).
(DHCP).
Dynamic Host
EIS
CLI Basics