Distribute-List Out - Dell PowerConnect M6348 Cli Reference Manual

distribute-list out

Use the distribute-list out command in Router OSPF Configuration mode to specify the access
list to filter routes received from the source protocol. Use the no form of the command to
remove the specified source protocol from the access list.
Syntax
distribute-list
no distribute-list
accesslistname — The name used to identify an existing ACL. The range is 1–31 characters.
•
• rip — Apply the specified access list when RIP is the source protocol.
• static — Apply the specified access list when packets come through the static route.
connected — Apply the specified access list when packets come from a directly connected
•
route.
Default Configuration
This command has no default configuration.
Command Mode
Router OSPF Configuration mode.
User Guidelines
This command has no user guidelines.
Example
The following example specifies the access list to filter routes received from the RIP source
protocol.
console(config-router)#distribute-list ACL40 out rip
enable
Use the enable command in Router OSPF Configuration mode to reset the default
administrative mode of OSPF in the router (active). Use the no form of the command to disable
the administrative mode for OSPF.
Syntax
enable
no enable
758
accesslistname
out {rip|static \ connected}
accesslistname
out {rip|static
\
connected}