HP ProCurve 7102dl Reference Manual page 1385

SROS Command Line Interface Reference Guide
network <address> <subnet mask>
Use the network command to enable RIP on the specified network. Use the no form of this command to
remove a network from the list.
Syntax Description
<address>
<subnet mask>
Default Values
By default, RIP is not enabled.
Functional Notes
The SROS will only allow processing (sending and receiving) RIP messages on interfaces with IP
addresses that are contained in the networks listed using this command. All RIP messages received on
interfaces not listed using this command will be discarded. To allow for receiving and participating in RIP
but not for transmitting, use the passive-interface command (refer to
page 1384).
Usage Examples
The following example enables RIP on the 192.168.72.252/30, 192.168.2.0/24, and 10.200.0.0/16
networks:
ProCurve(config)#router rip
ProCurve(config-rip)#network 192.168.72.252 255.255.255.252
ProCurve(config-rip)#network 192.168.2.0 255.255.255.0
ProCurve(config-rip)#network 10.200.0.0 255.255.0.0
5991-2114
Specifies IP address of the network on which RIP will be enabled.
Specifies subnet mask that corresponds to the entered IP address.
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Router (RIP) Configuration Command Set
passive-interface <interface>
on
1383