Quality Of Service (Qos) Map Commands - HP ProCurve 7102dl Reference Manual

SROS Command Line Interface Reference Guide
Q S
UALITY OF ERVICE
A QoS policy is defined using a QoS map in the CLI. The QoS map is a named list with sequenced entries.
An entry contains a single match reference and one or more actions (priority, set, or both). To activate the
QoS Command Set (which allows you to create and/or edit a map), enter a valid version of the QoS
command at the Global Configuration mode prompt. Multiple map entries for the same QoS map are
differentiated by a sequence number. The sequence number is used to assign match order.
Once created, a QoS map must be applied to an interface (using the qos-policy out <map-name>
command) in order to actively process traffic. Any traffic for the interface that is not sent to the priority
queue is sent using the default queuing method for the interface (such as weighted fair queuing).
For example:
ProCurve>enable
ProCurve#configure terminal
ProCurve(config)#qos map VOICEMAP 10
ProCurve(config-qos-map)#match precedence 5
ProCurve(config-qos-map)#priority 512
ProCurve(config-qos-map)#exit
ProCurve(config)#interface fr 1
ProCurve(config-fr 1)#qos-policy out VOICEMAP
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
do on page 1435
end on page 1436
exit on page 1437
ping <address> on page 1438
All other commands for this command set are described in this section in alphabetical order.
bandwidth [percent <value> | remaining percent <value> | <value>]
match on page 1395
priority on page 1401
set dscp on page 1403
set precedence <0-7>
5991-2114
(Q S) M
O
on page 1405
© Copyright 2007 Hewlett-Packard Development Company, L.P.

Quality of Service (QoS) Map Commands

C
AP OMMANDS
on page 1392
1391