HP ProCurve 7102dl Reference Manual page 1378

SROS Command Line Interface Reference Guide
join-prune-msg-interval <seconds>
Use the join-prune-msg-interval command to set a timing rate for PIM sparse join/prune messages. Use
the no form of this command to return to the default setting.
Syntax Description
<seconds>
Default Values
By default, the message interval is set to 60 seconds.
Usage Examples
The following example sets the interval for 50 seconds:
ProCurve(config)#router pim-sparse
ProCurve(config-pim-sparse)#join-prune-msg-interval 50
5991-2114
Specifies the PIM sparse join/prune message interval.
Valid range: 10 to 65,534 seconds.
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Router (PIM Sparse) Configuration Command Set
1376