Router (Pim Sparse) Configuration Command Set - HP ProCurve 7102dl Reference Manual

SROS Command Line Interface Reference Guide
R (PIM S
OUTER
To activate the Router (PIM Sparse) Configuration mode, enter the router pim-sparse command at the
Global Configuration mode prompt. For example:
ProCurve>enable
ProCurve#configure terminal
ProCurve(config)#router pim-sparse
ProCurve(config-pim-sparse)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
bind <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
do on page 1435
end on page 1436
exit on page 1437
ping <address> on page
section in alphabetical order.
join-prune-msg-interval <seconds>
rp-address <ip address> access-group <access-list-name>
spt-threshold <packets> infinity
5991-2114
) C
PARSE ONFIGURATION
1438All other commands for this command set are described in this
on page 1376
on page 1378
© Copyright 2007 Hewlett-Packard Development Company, L.P.

Router (PIM Sparse) Configuration Command Set

C
OMMAND
on page 1377
S
ET
on page 1431
1375