(5)
Remove 1 clip and 1 bushing.
(6)
Take off the exit roller by sliding it to the rear
side.
12.6.4
Exit sensor (S5)
(1)
Take off the fuser/paper exit unit.
P.12-14 "12.6.1 Fuser / Exit unit"
(2)
Release the stopper using a flathead
screwdriver.
(3)
Open the guide and slide it to the front side.
Then slide its rear hinge downward.
Note:
Keep the guide being slid to the front side
during the steps (3) and (4).
e-STUDIO182/212/242
FUSER / EXIT UNIT
Exit roller
© 2009 TOSHIBA TEC CORPORATION All rights reserved
12 - 16
Clip
Bushing
Fig. 12-15
Stopper
Stopper
Fig. 12-16
1
Guide
Fig. 12-17
2