Exit Misfeed; Clearing Paper Jams; In The Tray; In The Manual Tray - Toshiba e-studio 200s User Manual

Exit Misfeed

1
Remove any remaining page(s) from the ADF.
2
Open the ADF cover.
3
Remove the misfed documents from the document output
tray.
4
Close the ADF cover. Then load the removed page(s), if
any, back into the ADF.

Clearing Paper Jams

When a paper jam occurs, "Paper Jam" appears on the display.
Refer to the table below to locate and clear the paper jam.
Message Location of Jam
[Paper Jam 0] In the tray or manual
Open/Close Door tray
[Paper Jam 1] In the fuser area or
Open/Close Door around the toner
cartridge.
[Paper Jam 2] In the paper exit area
Check Inside
To avoid tearing the paper, pull out the jammed paper gently
and slowly. Follow the instructions in the following sections to
clear the jam.

In the Tray

1
2

In the Manual Tray

1
Go to
page 9.2
page 9.3
page 9.3
2
9.2
Troubleshooting
Remove the jammed paper in the tray by gently pulling it
straight out.
If there is any resistance and the paper does not move
when you pull, or if you cannot see the paper in this area,
check the fuser area around the toner cartridge. See
page 9.3.
Open and close the front door to resume printing.
Remove the jammed paper in the tray by gently pulling it
straight out.
If there is any resistance and the paper does not move
when you pull, or if you cannot see the paper in this area,
check the fuser area around the toner cartridge. See
page 9.3.
Open and close the front door to resume printing.