Upper Exit Roller / Lower Exit Roller - Toshiba e-STUDIO2330C Service Manual

(5) Remove 1 E-ring and take off the gear.
(6) Remove 2 E-rings and take off the 2 bushing
and upper exit roller.
(7) Remove the lower exit roller from the exit
flame. Slide the 4 lower exit rollers to
separate it from the 2 shafts.
Note:
When installing, be sure that the groove of
the shaft comes to the top.
16.6.19 Fuser belt center thermopile(THMP1) / Fuser belt rear
thermopile(THMP2)
Note:
Be sure not to touch the lens of the thermopile. If it is dirty, use a cloth with a small amount of
alcohol to clean it.
(1) Take off the fuser unit.
 P.16-17 "16.6.1 Fuser unit"
(2) Loosen 2 screws and take off the Fuser belt
thermopile cover.
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
Exit frame
Bushing
Fig. 16-75
Exit frame
Lower exit roller
Shaft
Lower exit roller
Fig. 16-76
Fig. 16-77
e-STUDIO2330C/2820C/2830C/3520C/3530C/4520C
16 - 41
Bushing
Gear
Upper exit roller
Lower exit roller
Shaft
Groove
Shaft
Fuser belt
thermopile cover
FUSER UNIT / PAPER EXIT SECTION
16