Interoperate With Non-Dell Bridges; Changing The Region Name Or Revision - Dell S6100 Configuration Manual

Example of Assigning and Verifying the Root Bridge Priority
By default, the simple configuration shown previously yields the same forwarding path for both MSTIs. The following example shows how
R3 is assigned bridge priority 0 for MSTI 2, which elects a different root bridge than MSTI 2.
To view the bridge priority, use the show config command from PROTOCOL MSTP mode.
R3(conf-mstp)#msti 2 bridge-priority 0
1d2h51m: %RPM0-P:RP2 %SPANMGR-5-STP_ROOT_CHANGE: MSTP root changed for instance 2. My
Bridge ID: 0:0001.e809.c24a Old Root: 32768:0001.e806.953e New Root: 0:0001.e809.c24a
R3(conf-mstp)#show config
!
protocol spanning-tree mstp
no disable
MSTI 1 VLAN 100
MSTI 2 VLAN 200,300
MSTI 2 bridge-priority 0

Interoperate with Non-Dell Bridges

Dell Networking OS supports only one MSTP region.
A region is a combination of three unique qualities:
• Name is a mnemonic string you assign to the region. The default region name is null.
• Revision is a 2-byte number. The default revision number OS is 0.
• VLAN-to-instance mapping is the placement of a VLAN in an MSTI.
For a bridge to be in the same MSTP region as another, all three of these qualities must match exactly. The default values for the name and
revision number must match on all Dell Networking OS devices. If there are non-Dell devices that participate in MSTP, ensure these values
match on all devices.
NOTE: Some non-Dell devices may implement a non-null default region name. SFTOS, for example, uses the Bridge ID, while
others may use a MAC address.

Changing the Region Name or Revision

To change the region name or revision, use the following commands.
• Change the region name.
PROTOCOL MSTP mode
name name
• Change the region revision number.
PROTOCOL MSTP mode
revision number
Example of the name Command
To view the current region name and revision, use the show spanning-tree mst configuration command from EXEC Privilege
mode.
Dell(conf-mstp)#name my-mstp-region
Dell(conf-mstp)#exit
Dell(conf)#do show spanning-tree mst config
MST region name: my-mstp-region
Revision: 0
MSTI VID
1 100
2 200-300
Multiple Spanning Tree Protocol (MSTP) 543