Show Vrrp - Dell Force10 Z9000 Reference Manual

Parameters
verbose
Command Modes VRRP
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.2.1.1
Example
FTOS(conf-if-vrid-4)#show con
vrrp-group 4
!

show vrrp

View the VRRP groups that are active. If no VRRP groups are active, the FTOS returns No Active VRRP group.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax show vrrp [vrrp-id] [interface] [brief]
Parameters
vrrp-id
interface
brief
(OPTIONAL) Enter the keyword verbose to view all VRRP group
configuration information, including defaults.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
virtual-address 119.192.182.124
(OPTIONAL) Enter the Virtual Router Identifier for the VRRP group to
view only that group. The range is 1 to 255.
(OPTIONAL) Enter the following keywords and slot/port or number
information:
•
•
•
•
•
(OPTIONAL) Enter the keyword brief to view a table of information
on the VRRP groups on the E-Series.
For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
For Port Channel interface types, enter the keywords port-
channel followed by the number. For the C-Series and S-
Series, the range is 1 to 128. For the E-Series, the range is 1 to
255 for TeraScale.
For SONET interfaces, enter the keyword sonet followed by
the slot/port information.
For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
For a VLAN interface, enter the keyword vlan followed by
the VLAN ID. The VLAN ID range is from 1 to 4094.
1477