Table 377: Radius Server Settings; Table 378: 802.1X Exclusion List; Table 379: 802.1X Port Settings - Juniper JUNOS OS 10.4 - FOR EX REV 1 Manual

Table 377: RADIUS Server Settings

Field
IP Address
Password
Confirm Password
Server Port Number
Source Address
Retry Attempts
Timeout

Table 378: 802.1X Exclusion List

Field
MAC Address
Exclude if connected
through the port
Move the host to the VLAN

Table 379: 802.1X Port Settings

Field Function
Supplicant Mode
Copyright © 2010, Juniper Networks, Inc.
Apply 802.1X Profile—Applies an 802.1X profile based on the port role. If a message
appears asking whether you want to configure a RADIUS server, click
802.1X Configuration—Configures custom 802.1X settings for the selected
interface. If a message appears asking if you want to configure a RADIUS server,
click Yes . Enter information as specified in Table 377 on page 2831. To configure
802.1X settings, enter information as specified in Table 379 on page 2831.
Delete—Deletes 802.1X authentication configuration on the selected interface.
Function
Specifies the IP address of the server.
Specifies the login password.
Verifies the login password for the server.
Specifies the port with which the server is associated.
Specifies the source address of the switch using which
the switch can communicate with the server.
Specifies the number of login retries allowed after a
login failure.
Specifies the time interval to wait before the connection
to the server is closed.
Function
Specifies the MAC address to be excluded from
802.1X authentication.
Specifies that the host can bypass authentication
if it is connected through a particular interface.
Specifies moving the host to a specific VLAN once
the host is authenticated.
Chapter 89: Configuring Access Control
Your Action
Enter the IP address in dotted decimal
notation.
Enter the password.
Reenter the password.
Type the port number.
Type the IP address in dotted decimal
notation.
Type the number.
Type the interval in seconds.
Your Action
Enter the MAC address.
Select to enable the option. Select the port
through which the host is connected.
Select to enable the option. Select the
VLAN from the list.
Your Action
.
Yes
2831