Juniper JUNOS OS 10.4 - FOR EX REV 1 Manual page 2923

Configuration
CLI Quick
Configuration
Step-by-Step
Procedure
Copyright © 2010, Juniper Networks, Inc.
Figure 67: Multiple Supplicants on an 802.1X-Enabled Interface
Connecting to a File Server
To configure firewall filters for multiple supplicants on 802.1X-enabled interfaces:
Configuring Firewall Filters on Interfaces with Multiple Supplicants on page 2819
Configuring Firewall Filters on Interfaces with Multiple Supplicants
To quickly configure firewall filters for multiple supplicants on an 802.1X-enabled interface
copy the following commands and paste them into the switch terminal window:
[edit]
set protocols dot1x authenticator interface ge-0/0/2 supplicant multiple
set firewall family ethernet-switching filter filter1 term term1 from destination-address
192.0.2.16/28
set firewall policer p1 if-exceeding bandwidth-limit 1m
set firewall policer p1 if-exceeding burst-size-limit 1k
set firewall family ethernet-switching filter filter1 term term1 then count counter1
set firewall family ethernet-switching filter filter1 term term2 then policer p1
To configure firewall filters on an interface enabled for multiple supplicants:
Configure interface
ge-0/0/2
1.
[edit protocols dot1x]
user@switch# set authenticator interface ge-0/0/2 supplicant multiple
Set policer definition:
2.
Chapter 88: Examples: Access Control Configuration
for multiple supplicant mode authentication:
2819