Table 10: Show Redundancy Clients Output Fields - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SERVICE AVAILABILITY CONFIGURATION GUIDE 2010-10-08 Configuration Manual

JunosE 11.3.x Service Availability Configuration Guide
Meaning
60
dhcpExternal
DHCP Proxy Client
DS1
DS3
ethernet
Flow Inspection
frameRelay
FT1
Global Ipv6
Global Ip
HDLC
IKEP
ipflowstats
IpSubscriberManager
IPTU
IPVR
IPsec Transport (ITM)
l2tpDialoutGenerator
l2tp
LMGR
DHCPv4 Local Server
DHCPv6 Local Server
MPLS
PMGR
pppoe
ppp
qos
Radius Relay Server
RSVP
SCM
slotHelper
Cisco HDLC
ServiceManager
Sonet
SonetPath
SonetVT
IPsec Tunnel (ST)
Table 10 on page 60 lists the show redundancy clients command output fields.

Table 10: show redundancy clients Output Fields

Field Name
client
mode
Configuration
supported safe
unsupported safe
supported safe
supported safe
supported safe
supported safe
supported safe
supported safe
unsupported safe
supported safe
supported safe
supported safe
supported safe
supported safe
supported safe
supported safe
unsupported safe
unsupported safe
supported safe
supported safe
supported safe
unsupported safe
supported safe
supported safe
supported safe
supported safe
supported safe
unsupported safe
supported safe
supported safe
supported safe
supported safe
supported safe
supported safe
supported safe
supported safe
supported safe
Field Description
High availability client.
High availability status of the client. Possible values:
supported or unsupported.
Safety level of the configuration based on whether or
not the client is supported or unsupported and in case
of those unsupported, whether or not the client has
been configured. For example, if an unsupported client
has been configured on a router with high availability
enabled, the configuration reads "unsafe".
Copyright © 2010, Juniper Networks, Inc.