Juniper JUNOS OS 10.4 - FOR EX REV 1 Manual page 2917

For ex series ethernet switches
Table of Contents

Advertisement

Meaning
Related
Documentation
Example: Configuring VoIP on an EX Series Switch Without Including LLDP-MED
Support
Requirements
Copyright © 2010, Juniper Networks, Inc.
ge-0/0/0.0
down
default
ge-0/0/1.0
down
employee-vlan
ge-0/0/5.0
down
employee-vlan
ge-0/0/3.0
down
employee-vlan
ge-0/0/8.0
down
employee-vlan
ge-0/0/10.0 down
default
ge-0/0/11.0 down
employee-vlan
ge-0/0/23.0 down
default
ge-0/0/2.0
up
voice-vlan
data-vlan
The field
shows that the
VLAN members
VLAN and
VLAN. The
voice-vlan
Example: Setting Up VoIP with 802.1X and LLDP-MED on an EX Series Switch on
page 2800
Example: Configuring VoIP on an EX Series Switch Without Including LLDP-MED Support
on page 2813
Understanding 802.1X and VoIP on EX Series Switches on page 2761
Understanding 802.1X and LLDP and LLDP-MED on EX Series Switches on page 2759
You can configure voice over IP (VoIP) on an EX Series switch to support IP telephones.
The Link Layer Discovery Protocol–Media Endpoint Discovery (LLDP-MED) protocol is
sometimes used with IP phones to forward VoIP parameters from the switch to the
phone. Not all IP phones support LLDP-MED, however.
This example describes how to configure VoIP on an EX Series switch without LLDP-MED
and without 802.1X:
Requirements on page 2813
Overview on page 2814
Configuration on page 2814
Verification on page 2816
This example uses the following hardware and software components:
Junos OS Release 9.1 or later for EX Series switches.
One EX4200 switch acting as an authenticator port access entity (PAE). The interfaces
on the authenticator PAE form a control gate that blocks all traffic to and from
supplicants until they are authenticated.
A IP phone that does not support LLDP-MED.
Before you configure VoIP, be sure you have:
Chapter 88: Examples: Access Control Configuration
unblocked
unblocked
unblocked
unblocked
unblocked
unblocked
unblocked
unblocked
unblocked
unblocked
interface supports both the
ge-0/0/2.0
field shows that the interface is up.
State
data-vlan
2813

Advertisement

Table of Contents
loading

This manual is also suitable for:

Junos os 10.4

Table of Contents