Juniper JUNOS OS 10.4 - FOR EX REV 1 Manual page 2911

Meaning
Purpose
Action
Meaning
Related
Documentation
Example: Configuring VoIP on an EX Series Switch Without Including 802.1X
Authentication
Copyright © 2010, Juniper Networks, Inc.
Authentication method: Radius
Authenticated VLAN: vo11
Dynamic Filter: match source-dot1q-tag 10 action deny
Session Reauth interval: 60 seconds
Reauthentication due in 50 seconds
The field Role shows that the
field shows that the interface is configured in multiple supplicant mode,
Supplicant
permitting multiple supplicants to be authenticated on this interface. The MAC addresses
of the supplicants currently connected are displayed at the bottom of the output.
Verifying the VLAN Association with the Interface
Display the interface state and VLAN membership.
user@switch> show ethernet-switching interfaces
Ethernet-switching table: 0 entries, 0 learned
user@switch> show ethernet-switching interfaces
Interface State VLAN members
ge-0/0/0.0 down default
ge-0/0/1.0 down employee-vlan
ge-0/0/5.0 down employee-vlan
ge-0/0/3.0 down employee-vlan
ge-0/0/8.0 down employee-vlan
ge-0/0/10.0 down default
ge-0/0/11.0 down employee-vlan
ge-0/0/23.0 down default
ge-0/0/2.0 up voice-vlan
data-vlan
The field VLAN members shows that the
VLAN and VLAN. The
voice-vlan
Example: Connecting a RADIUS Server for 802.1X to an EX Series Switch on page 2765
Example: Setting Up 802.1X for Single Supplicant or Multiple Supplicant Configurations
on an EX Series Switch on page 2788
Defining CoS Forwarding Classes (CLI Procedure) on page 3436
Defining CoS Forwarding Classes (J-Web Procedure) on page 3436
Configuring LLDP-MED (CLI Procedure) on page 2844
You can configure voice over IP (VoIP) on an EX Series switch to support IP telephones.
To configure VoIP on an EX Series switch to support an IP phone that does not support
802.1X authentication, you must either add the MAC address of the phone to the static
MAC bypass list or enable MAC RADIUS authentication on the switch.
Chapter 88: Examples: Access Control Configuration
ge-0/0/2.0 interface is in the authenticator state. The
Blocking
unblocked
unblocked
unblocked
unblocked
unblocked
unblocked
unblocked
unblocked
unblocked
unblocked
ge-0/0/2.0 interface supports both the
field shows that the interface is up.
State
data-vlan
2807