Figure 17: Example Of Pppoe Over Vlan With Ip Over Vlan Stacking Configuration - Juniper JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 Configuration Manual

JunosE 11.2.x Link Layer Configuration Guide
Figure 17: Example of PPPoE over VLAN with IP over VLAN Stacking Configuration Procedure
encapsulation ppp
encapsulation vlan
ip address
176
Use to configure PPP as the encapsulation method for the interface.
Example
host1(config-if)#encapsulation ppp
Use the no version to disable PPP on the interface.
See encapsulation ppp.
Use to configure VLAN as the encapsulation method for the interface.
Example
host1(config-if)#encapsulation vlan
Use the no version to disable VLAN on an interface.
See encapsulation vlan.
Use to set a primary or secondary IP address for an interface or subinterface.
Specify the layer 2 encapsulation before you set the IP address.
Copyright © 2010, Juniper Networks, Inc.