Access Switch - Juniper JUNOS OS 10.4 - FOR EX REV 1 Manual

Table 185: Components of the Topology for Connecting Virtual Chassis Access Switches to a
Virtual Chassis Distribution Switch
Hostname and
Switch VCID
SWA-0 Host-A Access
switch
VCID 1
Copyright © 2010, Juniper Networks, Inc.
NOTE: If the remote end of the LAG link is a security device, LACP might not
be supported because security devices require a deterministic configuration.
In this case, do not configure LACP. All links in the LAG are permanently
operational unless the switch detects a link failure within the Ethernet physical
layer or data link layers.
Figure 33: Topology for LAGs Connecting a Virtual Chassis Access Switch
to a Virtual Chassis Distribution Switch
Table 150 on page 943 details the topology used in this configuration example.
Base Hardware
EX4200-48P
switch
Chapter 57: Examples of Interfaces Configuration
Uplink Module Member ID
One XFP uplink 0
module
Trunk Port
xe-0/1/0 to SWD-0
to SWD-1
xe-0/1/1
1257