Juniper JUNOS OS 10.4 - FOR EX REV 1 Manual page 1368

Complete Software Guide for Junos
Step-by-Step
Procedure
Results
Verification
Purpose
Action
1264
®
OS for EX Series Ethernet Switches, Release 10.4
To configure LACP for Host D LAGs
Specify the aggregated Ethernet options for both bundles:
1.
[edit interfaces]
user@Host-D#set ae0 aggregated-ether-options lacp passive periodic fast
user@Host-D#set ae1 aggregated-ether-options lacp passive periodic fast
Display the results of the configuration:
[edit interfaces]
user@Host-D# show
ae0 {
aggregated-ether-options {
lacp {
passive;
periodic fast;
}
}
}
ae1 {
aggregated-ether-options {
lacp {
passive
periodic fast;
}
}
}
To verify that LACP packets are being exchanged, perform these tasks:
Verifying the LACP Settings on page 1264
Verifying That the LACP Packets Are Being Exchanged on page 1265
Verifying the LACP Settings
Verify that LACP has been set up correctly.
Use the show lacp interfaces interface-name
enabled as active on one end.
user@Host-A> show lacp interfaces xe-0/1/0
Aggregated interface: ae0
LACP state: Role
xe-0/1/0 Actor
xe-0/1/0 Partner
LACP protocol: Receive State
xe-0/1/0
and :
ae0 ae1
command to check that LACP has been
Exp Def Dist Col
No Yes No No
No Yes No No
Transmit State
Defaulted Fast periodic
Syn Aggr Timeout Activity
No Yes Fast Active
No Yes Fast Passive
Mux State
Detached
Copyright © 2010, Juniper Networks, Inc.