Juniper JUNOS OS 10.4 - FOR EX REV 1 Manual page 1306

Complete Software Guide for Junos
1202
®
OS for EX Series Ethernet Switches, Release 10.4
Chassis ISSU Check Done
ISSU: Validating Image
ISSU: Preparing Backup RE
Pushing bundle to re1
WARNING: A reboot is required to install the software
WARNING: Use the 'request system reboot' command immediately
Backup upgrade done
Rebooting Backup RE
Rebooting re1
ISSU: Backup RE Prepare Done
Waiting for Backup RE reboot
GRES operational
Initiating Chassis In-Service-Upgrade
Chassis ISSU Started
ISSU: Preparing Daemons
ISSU: Daemons Ready for ISSU
ISSU: Starting Upgrade for FRUs
ISSU: Preparing for Switchover
ISSU: Ready for Switchover
Checking In-Service-Upgrade status
Item
FPC 0
FPC 1
FPC 2
FPC 3
FPC 4
FPC 5
FPC 6
FPC 7
Resolving mastership...
Complete. The other routing engine becomes the master.
ISSU: RE switchover Done
Skipping Old Master Upgrade
ISSU: IDLE
When the upgrade is complete, the original master Routing Engine (
the backup Routing Engine.
To verify that the original backup Routing Engine (
5.
following command:
{backup}
user@switch> show version invoke-on all-routing-engines
re0:
----------------------------------------------------------------------
Hostname: switch
Model: ex8208
JUNOS Base OS boot [10.4-20100712.0]
JUNOS Base OS Software Suite [10.4-20100712.0]
JUNOS Kernel Software Suite [10.4-20100712.0]
JUNOS Crypto Software Suite [10.4-20100712.0]
JUNOS Online Documentation [10.4-20100712.0]
JUNOS Enterprise Software Suite [10.4-20100712.0]
LC JUNOS Installation Software [10.4-20100712.0]
JUNOS Routing Software Suite [10.4-20100712.0]
JUNOS Web Management [10.4-20100712.0]
re1:
----------------------------------------------------------------------
Hostname: switch
Status
Online
Online
Online
Offline
Online
Online
Online
Online
Reason
Offlined by CLI command
) becomes
re0
) has been upgraded, enter the
re1
Copyright © 2010, Juniper Networks, Inc.