Configuring Pppoe Over Vlan; Figure 14: Example Of Ip/Vlan/Fast Ethernet Stacking Configuration Procedure - Juniper JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010 Configuration Manual
For e series broadband services routers - link layer configuration
Hide thumbs
Also See for JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010:
- Configuration manual (788 pages)
Table of Contents
Advertisement
JUNOSe 11.0.x Link Layer Configuration Guide
Figure 14: Example of IP/VLAN/Fast Ethernet Stacking Configuration Procedure
Configuring PPPoE over VLAN
To configure PPPoE over VLAN over an Ethernet interface:
1.
2.
3.
4.
5.
6.
174
Creating a VLAN Subinterface
Specify a Fast Ethernet, Gigabit Ethernet, or 10-Gigabit Ethernet port.
host1(config)#interface fastEthernet 4/1
Specify VLAN as the encapsulation method.
host1(config-if)#encapsulation vlan
The VLAN major interface is added.
Create a VLAN subinterface by adding a subinterface number to the interface
identification command.
host1(config-if)#interface fastEthernet 4/1.1
Do one of the following:
Assign a VLAN ID for the subinterface.
host1(config-if)#vlan id 201
Assign a VLAN ID and the optional unique MAC address for the subinterface.
host1(config-if)#vlan id 201 mac-address 0090.1a01.1234
Specify PPPoE as the encapsulation method on the interface.
host1(config-if)#pppoe
Create a PPPoE subinterface.
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010 and is the answer not in the manual?
Questions and answers