New Holland T8010 Manual page 1475

Electro Hydraulic Remote #3 Lever Position Control Pot Data Is Set To The
Error State
Cause:
The Data Bus signaled that AUX 3 lever potentiometer (the 3rd remote hydraulic valve control) is set to the error
state. The AUX/Hitch/PTO controller received the signal from the armrest controller.
Possible failure modes:
1. AUX 3 lever potentiometer has failed in the armrest controller (in most cases).
2. Software execution error in the armrest controller (small chance).
Solution:
The 3rd remote lever position control pot, connector J203 plugs into the armrest controller. If the 3rd remote control
pot fails in the armrest controller, the fault code ARM 49 should exist.
1. Check for fault code ARM 49 at the armrest controller. If ARM 49 exists, follow the corresponding corrective
action.
2. Check the function the armrest controller through the Electronic Service Tool.
Connect the service tool to the tractor Data Bus, do the following:
Go to the Monitor screen by click the Monitor Icon.
Click the CHANGE PARAMETER SELECTIONS Icon.
Click the ARMREST AUX REMOTE 3 REMOTE CONTROL LEVER and then ADD. Next click EXIT. You will
now be able to monitor the 3 REMOTE CONTROL LEVER status on the screen.
NOTE: See schematic sections 45 on the schematic poster.
Electro Hydraulic Remote #4 Lever Position Control Pot Data Is Set To The
Error State
Cause:
The Data Bus signaled that AUX 4 lever potentiometer (the 4th remote hydraulic valve control) is set to the error
state. The AUX/Hitch/PTO controller received the signal from the armrest controller.
Possible failure modes:
1. AUX 4 lever potentiometer has failed in the armrest controller (in most cases).
2. Software execution error in the armrest controller (small chance).
Solution:
The 4th remote lever position control pot, connector J204 plugs into the armrest controller. If the 4th remote control
pot fails in the armrest controller, the fault code ARM 59 should exist.
1. Check for fault code ARM 59 at the armrest controller. If ARM 59 exists, follow the corresponding corrective
action.
2. Check the function the armrest controller through the Electronic Service Tool.
Connect the service tool to the tractor Data Bus, do the following:
Go to the Monitor screen by click the Monitor Icon.
Click the CHANGE PARAMETER SELECTIONS Icon.
Click the ARMREST AUX REMOTE 4 REMOTE CONTROL LEVER and then ADD. Next click EXIT. You will
now be able to monitor the 4 REMOTE CONTROL LEVER status on the screen.
NOTE: See schematic sections 45 on the schematic poster.
Section 55 - Electrical System, Controller - Chapter 3
AUX/HITCH/PTO FAULT CODE 110
AUX/HITCH/PTO FAULT CODE 111
55-3-56