Thermo Scientific AquaSensors
The System is used for continuous monitoring of dissolved oxygen from 0 ppm to 20 ppm. The
system also measures temperature from 0°C to 100°C. The optical sensor head is pre-
calibrated and the zero is factory set. The sensor retains calibration values and does not require
a new calibration when the system is connected to a new AV38 Display Unit, AquaPro, PC, or
PLC.
The communications supports measurement, calibration, configuration and diagnostics
functions which can be accessed locally or remotely without an analyzer or controller
electronics box.
Product Highlights:
0 to 20 ppm Measurement Range
•
Calibration stored in Sensor (Does not require recalibration after connection to
•
Analyzer/Controller)
Immersion and Float Mounting Options
•
0.01 ppm Resolution
•
Fast Response
•
Provides measurement, calibration, configuration and diagnostic functions without
•
Analyzer/Controller
Works with AV38/AquaPro for local display, current output data reporting, and relay control
•
with sensor wash.
Temperature measurement included
•
Serial Numbers
The system's serial number is engraved on the side of the unit. The cap serial number is
programmed into the cap's memory chip.
Unpacking the Sensor
1. Remove the sensor from the box and other packaging materials.
2. Unscrew the nose cone from the sensor and remove the red protective dust cap from the
sensor. Save the dust cap for later use.
Nose cone
Product Description
Dust cap
RDO Pro-X Optical Dissolved Oxygen Measurement System
Section 2
|
9
|