Write Backed-Up Parameters To The Drive; Verify Keypad Parameters And Drive Parameters - Omron Q2A Series Technical Manual

4.5 Keypad Operation
4.
Push or
5.
Push or
6.
Push or
7.
Push or
The keypad shows "End" when the backup procedure completes successfully.
◆

Write Backed-up Parameters to the Drive

You can back up parameters on the keypad and write them to different drives.
Note:
• Always stop the drive before you start to restore the parameter backups.
• The drive rejects Run commands while it is restoring parameters.
1.
Push (
Note:
• [ Home] appears in the upper right hand corner of the screen when in HOME mode.
• If [ ] is not shown on
2.
Push ( ).
3.
Push or
4.
Push or
5.
Push or
6.
Push or
7.
Push or
The keypad will show the "End" message when the write process is complete.
Note:
Different settings and conditions will change the keypad display.
A - A1-02 [Control Method] settings
B - o2-04 [Drive KVA Selection]
C - Presence of Q2pack parameter
◆

Verify Keypad Parameters and Drive Parameters

This procedure verifies that the parameter setting values that were backed up in the keypad agree with the
parameter setting values in the drive.
136
to select [Parameter Backup/Restore], then push
to select the items to back up, then push
to select [Bck (Drive → OPE)], then push
to select a memory location, then push
) to show the HOME screen.
, push ( ) to show [
to select [Configuration], then push
to select [Parameter Backup/Restore], then push
to select the item to restore, then push
to select [Res (OPE → Drive)], then push
to select the backed-up parameter data, then push
settings (2 or 3 digits)
backup
.
.
.
.
] on .
.
.
.
.
D - Parameter backup data is not
registered
E - Backup data does not contain the
date information
F - Backup date
SIEPYEUOQ2A01A AC Drive Q2A Technical Manual
.